Safety Instructions - MPI Ultrasonic generator Manual

SAFETY INSTRUCTIONS

Symbols in manual:
Before starting up your device, please read through the following instructions carefully, both for your own
safety and for the safety of the device.
Keep this manual where it can be readily accessed by all systems users.

Installation is to be carried out by qualified technical personnel only!

This ultrasonic generator is to be operated by properly trained personnel only!

Due to the way it operates, additional safety measures must be taken if the device is to be used in areas
posing an explosion risk.

The electromagnetic compatibility corresponds to the standards and regulations listed in the
specifications.

All necessary settings were either made in the factory or are described in this handbook.
However, should problems occur on start-up, please do not make any prohibited adjustments to the device, as
this would endanger your warranty rights. If in doubt, please contact our technical service staff.

Please contact our technical service if at all in doubt. Please see the last page.

Inspection or diagnostic work inside the device may only be carried out to the extent described and, as
with the electrical connection should only be performed by skilled personnel. When performing such
work, the ultrasonic generator must be completely disconnected from the main power source. (unplug
the mains connection).

The device must always be disconnected from the mains before cleaning or when installing/uninstalling
an option. Do not use liquid cleaners or sprays. Only use a damp cloth.
Immediate imminent danger – health and live
(bad injuries or dead)
hot surface.
Do not Touch!
Possible damage,
without danger for people
Electrical voltage!