Yamaha DVX-700 Owner's Manual page 75

Bluetooth
Status message
Searching...
Completed
Canceled
Not found
BT connected
Disconnected
Not Available
Note
In case of a transmission error without a status message appearing in the front panel, check your Bluetooth
component.
Disc
Problem
Some functions do not work.
Playback does not start, the sound or
picture is distorted or playback is
stopped halfway.
After loading a DVD-Video, the same
picture is usually displayed and you
cannot move to the main contents or
the main menu.
Cause
The Yamaha Bluetooth wireless audio
receiver (such as YBA-10, sold
separately) and the Bluetooth
component are in the process of the
pairing.
The Yamaha Bluetooth wireless audio
receiver and the Bluetooth component
are in the process of establishing the
connection.
The pairing is completed.
The pairing is canceled.
The system cannot find the Bluetooth
component while performing the
pairing or trying to connect to the
Bluetooth component.
The connection between the Yamaha
Bluetooth wireless audio receiver and
the Bluetooth component is
established.
The Bluetooth component is
disconnected from the Yamaha
Bluetooth wireless audio receiver.
The pairing is performed when the
Yamaha Bluetooth wireless audio
receiver is connected to the Bluetooth
component.
Cause
Not all discs support all of the disc
playback functions of this unit.
The disc is not properly set.
The disc is dirty.
The loaded disc in not supported.
Condensation on the pickup lens. When
this system is moved from a cold
environment to a warm one,
condensation may form on the pickup
lens.
The Resume/Last memory function is
effective.
TROUBLESHOOTING
Remedy
--
--
--
--
--
--
--
Perform the pairing when the Yamaha
Bluetooth wireless audio receiver is not
connected to the Bluetooth component.
Remedy
Try another disc.
Place the disc, label-side up.
Check the disc and clean as necessary.
Use only supported disc formats.
The Disc that is not compliant with the
CD Audio specification (e.g. copy
control CD, the non-DVD side of the
DualDisc, etc.) may not play.
Wait for one to two hours for the
condensation to evaporate, then try
again.
Press s twice to set the Resume
function to off.
Reset the DVD setting to the initial
factory settings (DVD INIT) to clear
the resume point.
See
page
--
--
--
--
--
--
--
8
61
See
page
2
26
2
2
--
29
65
71
En