Nordson iControl Instruction Sheet
Opto-input interface card replacement
Hide thumbs
Also See for iControl:
- Hardware manual (189 pages) ,
- Customer product manual (32 pages) ,
- Instruction sheet (6 pages)
Advertisement
Quick Links
Removing Interface Card
TO 48 BIT DIGITAL I/O MODULE
50 COND.
DIGITAL I/O
HARNESS
Figure 1
Old Interface Card with Wiring and Ribbon Cable Connections
E 2011 Nordson Corporation
iControlr Opto-Input Interface Card
This instruction sheet is to help guide the procedure needed to replace the
iControl opto-input interface card.
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
WARNING: Shut off all power to the system before beginning any
procedures.
1. See Figure 1. Disconnect all wiring at interface card. Save cables 1−3
for installation of the new interface card.
2. Disconnect the ribbon cable from the interface card and the computer.
Discard the ribbon cable.
3. Remove the four screws (4) securing the interface card. Save the
screws to install the new interface card.
1
2
3
4
4
1
5
6
7
8
9
3
Instruction Sheet
P/N 1107152A01
Replacement
2
Part 1107152A01
Advertisement
Related Manuals for Nordson iControl
Summary of Contents for Nordson iControl
- Page 1 Opto-Input Interface Card Replacement This instruction sheet is to help guide the procedure needed to replace the iControl opto-input interface card. WARNING: Allow only qualified personnel to perform the following tasks. Follow the safety instructions in this document and all other related documentation.
- Page 2 CAUTION: Plugging in a ribbon cable the wrong way may damage the cable or circuit boards when power is applied. Reversing the ribbon cable polarity of the cable from the iControl computer to the interface card will cause catastrophic failure of the iControl unit. Make sure the cables are connected correctly.
- Page 3 (1−3) from the removal procedure with the new interface card. NOTE: A blank Compact Flash card is included in the replacement kit to make a backup of the current data card. Table 1 iControl Discrete Input Cable Color Code Assignments CABLE COLOR INPUT BOARD FIELD...
- Page 4 Opto-Input Interface Card Replacement Installing New Interface Card (contd) 4. Use Figure 3 and Table 2 to configure jumpers and comb jumpers. JA16 JA17 JA18 50 COND. DIGITAL I/O RIBBON CABLE Comb Jumpers Note: Interface Card Kit comes with two 12 position comb jumpers.
- Page 5 Opto-Input Interface Card Replacement Configure iControl to Digital Interface Card To configure the iControl to the new digital interface card, go to the Gun Configuration screen (see Figure 4) and select the digital input card for PCLD782. Figure 4...
- Page 6 Opto-Input Interface Card Replacement Issued 07/11 Original copyright date 2011. iControl, Nordson, and the Nordson logo are registered trademarks of Nordson Corporation. Part 1107152A01 E 2011 Nordson Corporation...