Assembling The Light Kit - Hunter Abernathy Installation Manual

Partially install two light kit
screws, found in the
hardware bag, halfway into
the adapter plate as shown.
It does not matter which two
screw holes you choose.
Insert the third screw found in the
hardware bag, into place and then tighten all
three screws.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Ceiling Bracket Downrod

Assembling the LIght Kit

2 of 3
Light Kit Screw
bag
1 of 3
Light Kit Screw
bag
Connect the plug to the lower
switch housing. Make sure to
line up the colored markings
on the connectors and that the
connectors latch.
Assembling the Glass/Bulbs
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan Wiring
Feed the wire plug through the center hole of the
hood assembly. Align the keyhole slots in the hood
assembly with the two screws you just installed. Lift
the hood assembly so that the keyhole slots engage
the two screws, and twist counterclockwise to lock
the hood assembly into place.
Tab
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Canopy Blades Light
These are the
screws you
saved that
were attached
to the red flag.
Attach the lower switch housing
to the hood assembly using the
kept short light kit screws.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Glass Remote Remote Cradle
1886
2 of 2
Short Light
Kit Screw
8