Installing The Ubox Components - Hitachi DS7000 Series Installation Manual

6. Install all the UBox PSUs
For each UBox PSU, perform the following steps:
1. Check the UBox PSU position
Look at the label inside the PSU slot.
2. Press the latch of the UBox PSU
3. Push the UBox PSU in using the handle
4. Release the latch to secure the UBox PSU in place
2.4.5.

Installing the UBox Components

Procedure
1. Take hold of the new component.
2. Install all the UNB modules
For each UNB module, perform the following steps:
1. Check the handles of the UNB module are in the open position
Chapter 2. Installing the Server in the Rack Cabinet 2-43