Caimore CM520-6X Series User Manual page 31

27
level of it is low.
Chap
MS-Chap
MS-Chap-V2
Any: it will take one of four approaches to verify.
 MPPE: Way to encrypt --
NoMppe: No encryption.
Mppe-(40|128)
Mppe-StateFul
 Add Default Route: If it's checked, then all the data passing through the router will be
sent to PPTP tunnel. Also means, all the devices connected to the router are only allowed
to access external network through PPTP tunnel.
 NAT: If it's checked, the devices connected to the router can access PPTP server through
the tunnel. If not, then these devices only can access server via Internet.
 Specify Local IP / Specify Peer IP: If PPTP server allows it, router can specify a local
tunnel IP address.
 Tunnel Check Interval / Tunnel Check Times: After tunnel is built, in order to check
tunnel state, router will send LCP packet to server in every tunnel check interval. When
the number of tunnel-checking failures over the value of "Tunnel Check Times", router
will initiate to terminate the connection and send a request to rebuild the tunnel.
 Other Parameters: It's used in a situation where a special parameter is required to
negotiate when establishing a tunnel. In general, this parameter can be left in blank,
unless server is requiring a special negotiation parameter.
Format -- "novj;novjcomp", between each parameter should be separated by ";".
Notice:
a. If "Add Default Route" is checked, please modify the parameters in "Keep Online".
b. If your router is in LAN, please map the port 1723 to this router.
Add: 3F, 1st Building, 23# Wanghai Road, Xiamen
Web:http://en.caimore.com
厦 门 才 茂 通 信 科 技 有 限 公 司
Xiamen Caimore Communication Technology Co.,Ltd
Tel: +86-592-5902655
Fax:+86-592-5975885