Central Boiler Firestar Operation Manual page 13

Menu # Setting
RESET CYCLE OVER AIR START SETTING
13
Over air opening starting height as a percentage of full travel
when the RESET button is pressed . The actuator will decrease
from this setting to the end setting .
14 RESET CYCLE OVER AIR END SETTING
Over air actuator height as a percentage of full travel when
the RESET function has finished .
RESET CYCLE OVER AIR DURATION (MINUTES)
15
Sets the over air open duration when the furnace starts up
after being in Idle Mode . Helpful in reducing puff backs .
16 STOP CYCLE OVER AIR SETTING (PERCENTAGE)
17 PULSE CYCLE UNDER AIR SETTING
Under air actuator start height as a percentage of full travel
when the Pulse function is operating .
PULSE CYCLE OVER AIR SETTING
18
Over air actuator starting height as a percentage of full travel
when the Pulse function is operating .
19 PULSE CYCLE DELAY DURATION (MINUTES)
Time in minutes between pulses when furnace is in Idle
mode .
PULSE DURATION (MINUTES)
20
Time the fan is on and actuators are open during Pulse
function .
21 STOP CYCLE LENGTH (MINUTES)
After the water temperature setpoint is reached, the time the
over air continues to run to purge the firebox of smoke and
volatiles .
COMBUSTION TEMPERATURE SENSOR ERROR
22
(0=no error, 1=open circuit, 2=short to ground, 3=short to
5VDC) .
23 FAHRENHEIT/CELSIUS
(0 for Fahrenheit, 1 for Celsius) .
WATER TEMPERATURE OFFSET
24
This variable is added to (or subtracted from) the Water
Temperature Display .
25 COMBUSTION TEMPERATURE OFFSET
This variable is added to (or subtracted from) the Combustion
Temperature Display .
WI-FI ENABLED
26
(0=disabled, 1=enabled) .
27-40 Menu items 27-40 are variables used with the FireStar and
MyFireStar . c om systems .
FORGE OUTDOOR COAL FURNACE • OWNER'S MANUAL
Bituminous Anthracite
75 0
0 0
30 30
50 50
25 25
0 0
30 30
1 1
2 2
0 0
n/a n/a
0 0
0 0
0 0
13
MIN MAX
0 100
0 100
0 59
0 100
0 100
0 100
0 59
0 59
1 20
0 3
0 1
-30 30
-30 30
0 1