Central Boiler FireStar Operation Manual

Central Boiler FireStar Operation Manual

Hide thumbs Also See for FireStar:

Advertisement

Quick Links

For parts and accessories, service or repairs, call your authorized Central Boiler dealer or heating
contractor. Record the information below for future reference.
Serial Number
Dealership Name
Owner Name
OPERATION MANUAL
SOFTWARE VERSIONS 2.1 and 2.2
Installation Date
Phone Number
Save This Manual
For Future Reference
7-Oct-2014 • (p/n 9000257)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FireStar and is the answer not in the manual?

Questions and answers

Summary of Contents for Central Boiler FireStar

  • Page 1 ™ OPERATION MANUAL SOFTWARE VERSIONS 2.1 and 2.2 For parts and accessories, service or repairs, call your authorized Central Boiler dealer or heating contractor. Record the information below for future reference. Serial Number Installation Date Dealership Name Phone Number Owner Name...
  • Page 2 NOTES...
  • Page 3 Gas Ignitor and may be used to enable/disable the Auto Relight mode. Initial Start-up The FireStar controller is designed to cycle between NOTE: Before starting the outdoor furnace, make three operating modes to control the amount of fuel fed to...
  • Page 4 1.50). NOTE: Upon initial start-up, it is not uncommon for a substantial amount of condensation to be Setting the FireStar Controller for Heat Load present in the firebox as the furnace is coming up and Efficiency to operating temperature. This is normal and the The controller’s factory default settings allow the...
  • Page 5 If the heat demand is less than 50% of the Maxim’s other than wood pellets, it may be necessary to output capacity, it is not necessary for the FireStar change this setting. controller to shift into HIGH mode.
  • Page 6 To View All Heat Output Settings: To Change the Air Settings: 1. Press any of the buttons for the HIGH, 1. Press and hold the Air Adjust button; then MEDIUM or LOW modes. The light bars will press the button for the respective mode display the current heat output settings.
  • Page 7 Water Quality and Maintenance section. seconds. If adding water does not correct the problem, contact your Central Boiler dealer. Power Outage In the event of a power outage, the controller is High Water Temperature: the LED display will programmed to return to its previous state.
  • Page 8 Central Boiler, Inc. 20502 160th Street Greenbush, MN 56726 CentralBoiler.com ©2014 Central Boiler Printed in U.S.A. (p/n 9000257) • 7-Oct-2014...

Table of Contents