Table of Contents
Advertisement
COMPONENT NAMES (continued)
Remote control
POWER OFF button
POWER ON button
RGB/VIDEO buttons
MENU button
Loading Batteries
1. Open the battery cover.
• Slide back and remove the battery
cover in the direction of the arrow.
2. Load the batteries.
• Load the two Size AA batteries included, matching polarity
markings on the batteries to those on
the case.
3. Close the battery cover.
• Replace the battery cover in the direction of the arrow and snap
it back into place.
CAUTION
• Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
• When loading batteries, observe their correct polarities as
marked on the product. If loaded in the wrong direction, the
batteries could explode or leak, resulting in fires, physical injury,
or stains.
13
13
MUTE button
14
14
PinP button
34
AUTO button
16
16
OK button
16
ID button
16
14
VOL
RGB 1
RGB 2
MUTE
VOL
15
AV1
AV2
AV3
AV4
15
AUTO
PinP
SIZE
RECALL
MENU
16
OK
16
ID
ID SET
16
Handling the Remote Control
Use the remote control within about 5 m from the front of the unit,
within a 30 degree arc either side of the remote control sensor.
With in 30
degrees
About 3m
ATTENTION
• Do not drop exert undue force on the remote control.
• To avoid possible failures. Do not splash the remote control with
water or put it on a wet object.
• It you do not intend to use the remote control for an extended
period of time, remove the batteries from it.
• If the remote control begins to lack responsiveness, replace the
batteries.
• Strong light such as direct sunlight impinging on the
photoreceptor of the remote control can cause operational
failure. Position this unit to avoid direct contact with such light.
13
POWER ON/OFF button
VOLUME UP/DOWN buttons
SIZE button
RECALL button
RETURN button
SELECT/ADJUST buttons
ID SET button
With in 30
degrees
About 3m
About 5m
VOL
RGB 1
RGB 2
MUTE
VOL
AV1
AV2
AV3
AV4
AUTO
PinP
SIZE
RECALL
MENU
OK
ID
ID SET
9
Advertisement
Table of Contents
