Remote Control; Loading Batteries; Handling The Remote Control - Yamaha High Definition Plasma Monitor User Manual

COMPONENT NAMES (continued)

Remote control

POWER OFF button
POWER ON button
RGB/VIDEO buttons

Loading Batteries

1. Open the battery cover.
• Slide back and remove the battery
cover in the direction of the arrow.
2. Load the batteries.
• Load the two Size AA batteries included matching polarity
markings on the batteries to those on
the case.
3. Close the battery cover.
• Replace the battery cover in the
direction of the arrow and snap it back
into place.
CAUTION
• Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
• When loading batteries, observe their correct polarities as
marked on the product. If loaded in the wrong direction, the
batteries could explode or leak, resulting in fires, physical injury,
or stains.
MUTE button
PinP button
AUTO button
MENU button
OK button
ID button
VOL
RGB 1 RGB 2 MUTE VOL
AV1 AV2 AV3 AV4
AUTO PinP SIZE RECALL
MENU
OK
ID ID SET

Handling the Remote Control

Use the remote control within 5 m from the front of the unit, and
within a 30 degree are either side of the remote control sensor.
ATTENTION
• Do not drop or exert undue force on the remote control.
• To avoid possible failures. Do not splash the remote control with
water or put it on a wet object.
• If you do not intend to use the remote control for an extended
period of time, remove the batteries from it.
• If the remote control begins to lack responsiveness, replace the
batteries.
• Strong light such as direct sunlight impinging on the
photoreceptor of the remote control can cause operational failure.
Position this unit to avoid direct contact with such light.
POWER ON/OFF button
VOLUME UP/DOWN buttons
SIZE button
RECALL button
RETURN button
SELECT/ADJUST buttons
ID SET button
With in 30
With in 30
degrees
degrees
About 3m
About 3m
About 5m
VOL
RGB 1 RGB 2 MUTE VOL
AV1 AV2 AV3 AV4
AUTO PinP SIZE RECALL
MENU
OK
ID ID SET