Introduction - Crystal nVision Reference Recorder Operation Manual

Introduction

Thank you for choosing the nVision Reference Pressure Recorder from Crystal Engineering Corpo-
ration. Your nVision is a combination of leading edge technology and rugged industrial design.
Accuracy is up to 0.025 percent of reading - so any nVision can typically replace several gauges
or calibrators you may have been using. The nVision is fully temperature compensated - so there
is no change in accuracy throughout the entire operating temperature range!
The nVision features two identical bays allowing configuration of the reference recorder to meet
your requirements. All modules are field-replaceable allowing you the flexibility to react to
changing needs and module calibration requirements.
The nVision's case is made from a rugged injection molded polymer utilizing a gasket to seal the
enclosure against dust and water intrusion. Even the mini USB B connector is fully sealed (with
or without the protective boot cover). Circuitry is mounted in a shock-absorbing elastomeric
system and the batteries are easily accessible by removing four captive screws.
Other features include:
•
Log and display 500,000 points at up to 10 readings
per second on up to two modules simultaneously
•
Interactive real-time graphing of measurements
•
ATEX / IECEx Scheme intrinsically safe
(nVision Reference Recorder only)
•
IP67 rated enclosure —1 meter immersion for 30
minutes (nVision Reference Recorder only)
•
Uses Crystal's new CPF fittings and hose system
(leak-free and finger-tight to 10 000 PSI (700 bar))
We hope your nVision meets your expectations, and we're
interested in any comments or suggestions you may have.
You can send us a note at: sales@crystalengineering.net.
Many features in this and our other products are a direct
result of your comments!
Crystal Engineering is the company that designs, man-
ufactures, markets and services the nVision reference
recorder , XP2i series pressure gauges, 30 series pres-
sure calibrators, MultiCal multimeter pressure adapters
and a variety of industry specific pressure measuring
equipment. Crystal Engineering pioneered features like
full temperature compensation and "of reading" rated
gauges and calibrators. Pressure measuring equipment
is the only thing we do and that's why we say:
PRESSURE is Our BUSINESS ™
nVision Operation Manual
Your nVision can also be customized
to meet your specific test needs
through the use of CrystalControl™
software. Your personal computer
can disable, enable or modify a
variety of features of your nVision.
Look for the
logo for user programmable
features, like:
•
User defined pressure units, and/
or disable unused pressure units
•
Password protection to prevent
unauthorized changes to gauge
settings and/or product keypad
access
•
Expand or decrease allowable
Zero range
•
Set the gauge to a different
density of water factor
(4°C, 60°F or 68°F)
•
Store custom ID or tag numbers
in non-volatile memory
•
Adjust calibration values
• Page 1