Recording; Navigation.&.Select.buttons; Back.button; Record.button - Crystal nVision Reference Recorder Operation Manual

Page 8 • Crystal Engineering Corporation

Recording

.
X
Start Stop
You may or
Never remove power (either battery or USB power) when Recording.
CAUTION:
Additionally you may
memory capacity of the nVision. When this command is selected, the nVision will erase the full
on-board memory in less than 2 minutes.
CAUTION: Never remove power (either battery or USB power) during the erasing process.
In order to permanently archive your data, it is recommended to save any
data files via the Export Data
.Navigation.&.Select.buttons
Whenever you need to navigate, the nVision utilizes
arrow navigation buttons. Any time you need to select an object, press the
center
.

.Back.button

Pressing the
(opposite of next button).
.

.Record.button.(.

Recording a data run is simple with the nVision. To
flash) a recording run from any screen simply press the record button for one second. Record-
ing logs all the available data, so even if you are viewing the lower module numerical display,
the upper data will be recorded and available for CrystalControl downloading, viewing and
archiving. The recording or Logging interval of your nVision can be viewed in the Chassis Sum-
mary Screen, located in the Setup menu.
The product has the capability to record at rates from 10 readings per sec-
ond to 1 reading per hour as set in CrystalControl. Adjust your recording rate to optimize bat-
tery life and data recording needs to your specific application. Note that the nVision will record
all data related to the units checked as "available" in CrystalControl and listed in the
screens. Units that are not checked as "available", will not be available for downloading, viewing,
or archiving in CrystalControl.
Your nVision memory has capability to record approximately 500,000 data points if both module
bays are populated. If you have one bay populated, this number doubles.
The Automatic Shutoff timer will not shut off your nVision while recording.
Recording
a run from the
Erase All Runs in order to effectively manage the 500,000 data point
file feature in CrystalControl.
select
button.
back
button allows you to go backward through the available screens
.)
menu item.
start (LEDs solid) or
up/down left/right
and
stop (LEDs
Summary