Utp (Stp) Cable - Yamaha DRCX User Manual

2-14-3

UTP (STP) cable

The Ethernet cables are standardized by ANSI/TIA/EIA568A. To avoid miswiring and
malfunction, we recommend using cables conforming to this standard. When using
10BASE-T cables, it must have transmission characteristics of category 3 or higher.
■ Straight-through cable
Use this cable to connect the HUB to the controller and other party's device.
Signal name
TD+
TD-
RD+
Not use
Not use
RD-
Not use
Not use
■ Crossover cable
Use this cable to connect the controller directly with other party's device. This cable is
also used to connect HUBs in cascade(when HUBs have a cascade port).
Signal name
TD+
TD-
RD+
Not use
Not use
RD-
Not use
Not use
Between T-568A
Color Pin No
Green/White 1
Green 2
Orange/White 3
Blue 4
Blue/White 5
Orange 6
Brown/White 7
Brown 8
* Pins 4, 5, 7, 8 are not used for 10BASE-T.
* Straight-through cable also connects between T-568B and T-568B.
Between T-568A
Color Pin No
Green/White 1
Green 2
Orange/White 3
Blue 4
Blue/White 5
Orange 6
Brown/White 7
Brown 8
37
CHAPTER2 Ethernet Unit
Between T-568A
Pin No Color
1
Green/White
2 Green
3 Orange/White
4 Blue
5 Blue/White
6 Orange
7 Brown/White
8 Brown
Between T-568B
Pin No Color
1 Orange/White
2 Orange
3 Green/White
4 Blue
5 Blue/White
6 Green
7 Brown/White
8 Brown
* Pins 4, 5, 7, 8 are not used for 10BASE-T.
Signal name
TD+
TD-
RD+
not use
not use
RD-
Not use
Not use
Signal name
TD+
TD-
RD+
not use
not use
RD-
Not use
Not use