Connecting Speakers And Subwoofer; Connecting Speakers; Connecting A Subwoofer - Yamaha M170 Owner's Manual

RUNNING H/F 1

CONNECTING SPEAKERS AND SUBWOOFER

Connecting speakers

Follow the procedure below to connect speakers to this
unit. For information on your speakers, refer to the
owner's manual for the speakers.
Notes
• Do not connect the power cable of this unit until all cable
connections are completed.
• Be sure to connect the left channel (L), right channel (R), "+" (red)
and "–" (black) properly. If the connections are faulty, no sound
will be heard from the speakers, and if the polarity of the speaker
connections is incorrect, the sound will be unnatural and lack bass.
• Do not let the bare speaker wires touch each other or do not let
them touch any metal part of this unit. This could damage this
unit and/or the speakers.
• Use speakers with the specified impedance shown on the rear
panel of this unit.
R speaker
+
_
1
Remove approximately 10 mm of insulation
from the end of each speaker cable and twist
the exposed wires of the cable together to
prevent short circuits.
10 mm
6
L speaker
+
OUT
SUBWOOFER
_
SPEAKERS
2
Unscrew the knob.
3
Insert one bare wire into the hole in the side
of each terminal. And then tighten the knob
to secure the wire.

Connecting a subwoofer

Connect the SUBWOOFER OUT jack on this unit
to the INPUT jack on the subwoofer using a
subwoofer cable.
IN
AUX 2
OPTICAL +
DIGITAL
OUT
_
Note
Do not connect the power cable of this unit or subwoofer until all
cable connections are completed.
Red: positive (+)
Black: negative (–)
Red:
positive (+)
Black:
negative (–)
Subwoofer
INPUT
+
OUT
SUBWOOFER
_
SPEAKERS
IN
IN
A
AUX 2