Advertisement
PIE-1 CONNECTION TABLE FOR SIP SERIES
Model name
SIP-100
SIP-5030, 404/5, 4010/5, 3020/5
SIP-404, 4010, 3020
Be sure to insulate the cables you are not using.
AFTER INSTALLATION
3
(1) Before using PIE-1, set the IP addresses of PIE-1
and the computer in the following procedure.
The default settings of PIE-1 are as follows.
IP Address:
Subnet Mask:
Defoult Gateway:
1. Set the local area connection.
An example of IP address settings
IP Address
Subnet Mask
2. Using Internet Explorer, access the site below.
(http://192.168.0.126/)
3. Enter the user ID and the password below.
User ID:
PIE-1
Password: OPTEX
4. Change the IP address if necessary.
5. Select the detector you have connected.
6. After changing settings. Click "Save Config"
button.
Alarm 6-pin cable
Orange pair Yellow pair Green pair
Far
Near
Alarm
-
-
Alarm
192.168.0.126
255.255.255.0
0.0.0.0
192.168.0.1
:
255.255.255.0
:
Alarm 4-pin cable
Blue pair Purple pair
Creep
Tamper
Creep
Tamper
-
Tamper
Caution
7. Click "Overview" button. Confirm the settings in
the Overview screen.
Download the detailed instructions at our site.
(http://www.optex.co.jp/e/redwall/download/index.html)
(2) Confirm the output of the Event Code, and set
VMS/NVR.
(3) After setting VMS/NVR, conduct a walk test.
4
RESETTING
If you forget the IP address you have set, reset it to
obtain the default IP address in the following procedure.
1. Pull off the cable connected to the Ethernet
connector for PoE.
PIE-1 turns off.
2. While pressing the
RESET button,
connect the cable to
the Ethernet
connector for PoE
again. PIE-1 turns on.
3. Keep pressing the RESET button until the
green and yellow LEDs both go off. (They go off
within ten seconds.)
4. Release the RESET button. The software
restarts, and PIE-1 obtains the default IP
address.
Power 2-pin cable
Red
Trouble
(+)
Trouble
(+)
Trouble
(+)
Black
(-)
(-)
(-)
Advertisement
