Cleaning; Troubleshooting - CombiSteel 7455.22 Series User Manual

CLEANING

To prevent any electrical shock hazards or injury by rotating circulation fan, always
WARNING
disconnect the power cord plug from the wall outlet before cleaning.
Exterior and cooler compartment
Wipe the exterior and cooler compartment of the unit with a soft, dry cloth. If very soiled, wipe with a cloth that
has been moistened with a detergent. Then wipe with a cloth that has been dipped in water.
Do not splash water directly onto the cooler and do not wash with water.
WARNING
Short-circuiting and electrical shock could result.

Clean the cooler regularly to keep it clean at all times.

Never use polishing powder, soap powder, gasoline, oil or hot water
as these will damage the painting and plastic components.
Checks after cleaning
To ensure the safety, perform the following checks after cleaning the unit.

Make sure that the power plug is firmly inserted into a dedicated wall outlet. Confirm that the plug is not
abnormally hot.

Check the power cord for cracks and damage. Should the slightest irregularity be observed, contact the
dealer form whom you have purchased the unit.

TROUBLESHOOTING

In case the unit shows operating problems, check the following before calling the authorized service agent.
Problems
The unit is not operating
Not reaching the desired
temperature
Excessive noise
Water on the floor
Possible Causes
Faulty electrical contact
Poor electrical power
Thermostat set to the minimum
position
Unit is exposed to direct sunlight.
Thermostat is not properly adjusted.
Door(s) not properly closed
Products poorly distributed or excess
product load
Clogged condenser
Blocked grills
For models with electronic
temperature controller, indicates E0 or
E1.
The unit is not properly levelled.
Something is in contact with the
appliance, e.g. boxes, mops, brushes,
etc.
Drain hose is outside of the drain pan.
Possible Solutions
Verify electrical connections.
Check the power connection and
electrical outlet.
Adjust the thermostat setting to a
higher number.
Relocate the unit to a shaded area.
Adjust the thermostat setting to a
higher number.
Check the levelling of the unit and
door seal.
Redistribute the product load
according start instructions.
Clean the condenser.
Clean the grills of any debris collected.
Unplug the unit from the outlet. If the
error continues, contact an authorized
service technician.
Level the unit, making sure all the feet
are in firm contact with the floor.
Keep the objects away from the
appliance.
Lovate the hose in the drain pan.
8