Page 1
6000 Series AUTOMATED AC POWER SOURCES For the following models: 6005, 6010, 6020, 6040 SAFETYCHECKLIST KEEP unqualified/unauthorized personnel away from test area ARRANGE test stations in a safe and orderly manner NEVER touch products or connections during a test STOP the test first in the event of a problem...
Page 2
FRONTPANELCONTROLS POWER SWITCH: Rocker style power switch with international ON ( | ) and OFF (0) markings. GRAPHIC LCD: 240 x 64 Monographic LCD. SOFT KEYS: Multifunctional keys used to select parameters, select screens, and edit parameters. NUMERIC KEYPAD: Keys used to enter numeric data. DELETE KEY: Used to delete text characters and numeric data.
Page 3
BACKPANELCONTROLS (6005/6010 Back Panel) THERMAL FANS: Used to cool the instrument. REMOTE OUTPUT CONNECTOR: Provides output to monitor PASS, FAIL, Test-In Process via relay contact closures. SYNC OUTPUT CONNECTOR: Provides the capability to monitor a 5 VDC output signal. USB/RS-232 INTERFACE CARD: Interface card used to control, program, and capture data via a serial interface.
Page 4
BACKPANELCONTROLS (6020 Back Panel) TERMINAL POWER BLOCK: 208 VAC ± 10% max input voltage or 230 VAC ± 10% (Opt. 01) for input voltage. Output voltage 300 VAC max & 18.4 A max current. Only available on the 6020 model. Neutral Input Terminal: Neutral screw terminal.
Page 5
TESTSETUP SETTING UP A TEST IN MANUAL MODE: When the AUTO RUN parameter in the System Parameters menu is set to MANUAL Mode and you are in the set screen the display will be as follows: (See Figure 1) (Figure 1. Set Screen) To initialize the test, press the Test/Reset key and the LED for the key will illuminate.
Page 6
TESTSETUP SETTING UP A MULTIPLE STEP TEST IN PROGRAM MODE: PROGRAM Mode will run your test routine according to the parameters that have been entered within the Test Parameters screen. In most cases there will be a test time associated with PROGRAM Mode unless the time has been selected to ∞ or the cycle mode is ON.
Page 7
If the test passes you will see PASS. If you press the Exit soft key the screen will reset back to the set screen. USING THE 6000 SERIES IN CONSTANT CURRENT MODE 1) Turn ON the OC FOLD parameter. From the Set screen, press the “<more>” soft key. In the next screen, press the “System”...
Need help?
Do you have a question about the 6000 Series and is the answer not in the manual?
Questions and answers