Advertisement
EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR
Thank you for purchasing the MODWAY OFFICE CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
EEI-272/ EEI-3417
Components:
1. Base
x1
4. Back with Control Mechanism
Customer Service 908-368-1025︱www.modway.com
EEI-273/EEI-3418
2. Cylinder Column
x1
Hardware:
Bolt M8x45mm
A.
Crash Pad
B.
Cap Cover
C.
Allen Wrench
D.
x1
3. Castor
5. Arm
x4
x4
x4
x1
x5
x2
Page 1 of 4
Advertisement
Table of Contents
Related Manuals for modway EEI-272
Summary of Contents for modway EEI-272
- Page 1 EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR Thank you for purchasing the MODWAY OFFICE CHAIR. Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions.
- Page 2 EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR STEP 1: 1. Please put Base (1) on a carpeted or padded surface. 2. Insert 5 pieces of Castors (3) into the Base (1) as shown by hand. 3. Repeat the same steps for the remaining 4 pieces of Castors (3).
- Page 3 EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR STEP 3: 1. Attach 1 piece of Arm (5) to the Back with Control Mechanism (4) by using 2 pieces of Bolts (A) with 2 pieces of Crash Pads (B) as shown, Tighten Bolts (A) by using Allen Wrench (D) and attach 2 pieces of Cap Covers (C) to the holes on Arm (5) by hand as shown.
- Page 4 EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR STEP 5: Assembly is complete. Your office chair is ready to be used now! Attention: When you use the handle to adjust the height to be lower, please move away your legs from the foot ring at the same time.
Need help?
Do you have a question about the EEI-272 and is the answer not in the manual?
Questions and answers