Checking The Connections; Testing The Connections - Bose Free Space 51 Owner's Manual

Figure 6
Connecting cord to receiver

Checking the connections

Testing the connections

Check the speaker connections carefully. Make sure no loose strands of wire touch across
terminals. This could create short circuits and damage an amplifier or receiver.
Tighten any loose connections before you plug in the receiver/amplifier.
To make sure your speakers operate correctly, follow these steps:
1. Center the balance control on your receiver/amplifier.
2. Set the stereo/mono control to MONO.
3. Play some passages of music containing deep bass through the speakers.
The sound should seem to come from a point between the two speakers. The bass should be
full and natural. If not, the connections may be reversed, causing the speakers to play out of
phase. To correct the problem, make sure all the cords are connected positive to positive (+
to +) and negative to negative (– to –).
Setting Up
7