Choosing A Location For The Printer - Xerox PHASER 6140 User Manual

Choosing a Location for the Printer

1. Select a dust-free area with temperatures between 10°–32°C (50°–90°F), and relative humidity
between 15–85%.
Note: Sudden temperature fluctuations can affect print quality. Rapid heating of a cold room can
cause condensation inside the printer, directly interfering with image transfer.
2. Place the printer on a level, solid, non-vibrating surface with adequate strength for the weight of
the printer. The printer should be horizontal with all four feet in solid contact with the surface. The
printer weight, without the options or paper, is 18.4 kg (40.57 lb.). With the 250-sheet feeder, the
duplex unit, and consumables, the weight is 23.8 kg (52.47 lb.).
3. Ensure your printer has the proper amount of clearance for all of its features, including any options
you purchased. See the following measurements.
The recommended minimal spacing for the printer is:
Overhead Clearance:
200 mm (7.9 in.) above the printer for clearance when opening the front door
Height Requirement:
• Printer: 415 mm (16.3 in.)
• With 250-sheet feeder: add 108 mm (4.25 in.)
Other Clearances:
• 100 mm (3.9 in.) behind the printer
• 600 mm (23.6 in.) in front of the printer
• 100 mm (3.9 in.) on the left side of the printer
• 250 mm (9.8 in.) on the right side of the printer
4. After positioning the printer, you are ready to connect it to the power source and computer or
network. Go to the next section, Connecting the Printer
Installation and Setup
on page 32.
Phaser 6140 Color Laser Printer 31
User Guide