Before Use; Intended Use - aidapt VM903 Usage And Maintenance Instructions

INTRODUCTION
Thank you for deciding to purchase the Scoop Plate from Aidapt. The Scoop Plate is
manufactured from the finest materials available. When used correctly it is
designed to give many years of reliable, trouble-free service.

BEFORE USE

Carefully remove all packaging. Avoid using any knives of other sharp instruments
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
do not use your product, but contact your supplier for support.

INTENDED USE

This useful Scoop Plate has a secure, non-slip suction base to grip a hard, flat
surface such as a table, trolley or lap tray and is specially shaped with an extended
lip section on one side to make it possible to scoop food into a spoon or onto a fork
using one hand, assisting independent dining.
INSTRUCTIONS FOR USE
Ensure that the surface on which you will be positioning the Scoop Plate is
•
clean and dry.
Position the Scoop Plate as desired then press down to secure it to the
•
surface with the built-in non-slip suction base.
Fill the Scoop Plate and use the specially shaped raised lip to scoop food
•
onto a fork or spoon by pushing the utensil against and up the side of the
raised lip.
To remove the plate break the suction by raising one edge slightly and lifting
•
the suction base, then twist the base to fully release the suction and lift it
free from the surface.
NB. If the plate is not empty, care must be taken when removing it from the
surface to avoid spillage.
Usage and Maintenance Instructions
2
Ver. 2 07/2012 (2167)