Table of Contents
Advertisement
STEP 1
BLADE ASSEMBLY
DANGER
TO PREVENT INJURIES:
Rear Blade components are very heavy and can
injure a person should they suddenly fall from a lifting
device or improvised supports. Always make certain
components are properly secured before lifting and
properly supported on the ground before removing
lifting device. Always keep feet and other extremities
clear of areas where components can fall.
Insert blade pivot (item 1) through pivot hole in main
frame (item 2).
Secure the blade pivot into the main frame using a
nylon insert lock nut 1-1/8" (item 3)
Screw until vertical play is removed from pivot shaft.
Hint : screw until blade cannot rotate freely then
unscrew 1/8 turn or until the blade is able to rotate
freely.
Line up turntable holes in blade assembly (item 4)
and mainframe assembly and insert lock pin (item 5).
Then secure lock pin with cotter pin (item 6).
Lower parking stand (item 7) by pulling the lock pin
(item 8) in hole B.
Install the pin (item 1) on both side of the blade using
lock washer (item2) and nut (item 3) as illustrated.
ASSEMBLY
6
Advertisement
Table of Contents
