Table of Contents
Advertisement
ALWAYS PRACTICE SAFE MAINTENANCE
WARNING
TO PREVENT INJURIES:
Park the vehicle on a flat surface in a well ventilated
area.
Disengage the P.T. O.
Apply parking brake.
Stop the engine and remove the ignition key.
Wait until all moving parts have stopped before
leaving the driver's seat.
Always understand the procedures before doing any
work. Use the proper tools and equipment, refer to
the Owner's manual for additional information.
Always work in a clean dry area.
Lower the attachment to the ground, put tractor in
park, turn off the engine and remove key before doing
any maintenance.
Let the accessory cool before doing any work on it.
Disconnect the
battery ground
servicing or adjusting electrical systems or before
welding on the accessory.
Do not grease or oil the accessory while it is in
operation unless otherwise specified.
Inspect all parts. Make sure parts are in good
condition & properly installed.
Remove any build-up of grease, oil or debris.
Remove all tools and unused parts from accessory
before operating.
Proper servicing and adjustments are the key to long
life of any accessory. With careful inspection and
routine maintenance you can avoid costly repairs and
MAINTENANCE & STORAGE
cable(-) before
DANGER
TO PREVENT INJURIES:
Always check all hardware for tightness before using
or working around the blade. The moldboard will fall
off if blade pivot nut is missing.
LUBRICATION POINTS
Grease the moldboard and blade when storing for an
extended period of time.
Type of lubrication: Multi-purpose grease
Quantity: Coat Generously
LONG TERM STORAGE
Clean, inspect, service and make necessary repairs
to the rear blade when parking it for long periods and
when parking it at end of working season. This will
ensure that the blade is ready for use next time you
need it.
DANGER
TO PREVENT INJURIES:
Always support underside of rear blade with solid
blocking before working beneath unit. Never work under
equipment supported by hydraulics. Hydraulics can
drop equipment instantly if controls are actuated even
when power to hydraulics is shut off.
Clean off any dirt that may have accumulated on the
rear blade and thoroughly wash surfaces with a
garden hose.
Inspect blade for loose, damaged, or worn parts and
hardware. Adjust and tighten loose parts. When
needed replace parts with genuine manufacturer's
parts.
Repaint parts where paint is worn or scratched to
prevent rust.
Replace all damaged or missing decals.
Lubricate as noted under Lubrication Points.
A coating of oil or grease may be applied to the
moldboard and blade to minimize oxidation.
Store rear blade on a level surface in a clean dry
place. Inside storage will reduce maintenance and
make for a longer life span.
15
Advertisement
Table of Contents
