Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Morris MTFH-16401
Summary of Contents for Morris MTFH-16401
- Page 1 OWNER’S MANUAL PTC FAN HEATER MODEL: MTFH-16401 This product is only suitable for well insulated spaces or occasional use. PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS PICTURES IN THE MANUAL ARE FOR REFERENCE ONLY AND IS SUBJECT TO THE PHYSICAL PRODUCT IN THE PACKING BOX...
-
Page 2: Important Safety Information
INTRODUCTION • Before using your new heater, please carefully read through the following instructions. • KEEP THIS BOOKLET IN A SAFE PLACE SO THAT YOU MAY CONSULT IT LATER. • After removing the packaging, make sure that the appliance is in good condition. •... - Page 3 • Do not place appliance close to a radiant heat source. • Do not operate in areas where gasoline, paint or other flammable liquids are used or stored. • This appliance heats up when in use. To avoid burns, do not let bare skin touch hot surfaces.
- Page 4 • Use this appliance only as described in this manual. Any other use is not recommended by the manufacturer and may cause fire, electric shock, or injury. • A common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are removed regularly by unplugging the appliance and vacuum-cleaning air vents and grilles, where available.
- Page 5 • Do not twist, kink or wrap the cord around the appliance, as this may cause the insulation to weaken and split. Always ensure that the cord has been fully removed from any cord storage area before use. • Do not store appliance in a box or closed space until it has cooled down sufficiently.
- Page 6 • Do not connect the appliance to the mains source until it has been installed in its final location and adjusted to the position it will be used in. • This appliance is not intended for use in bathrooms, laundry or similar locations which may be exposed to water, moisture or humidity.
-
Page 7: Pre-Startup Check
PART FIGURE Control panel Remote-control unit take-in Display screen Remote control Rear shell Air outlet Power switch Pre-startup check 1. If power line is in good condition. 2. Product voltage is 220-240V AC, bearing capacity of product socket is no lower than 10A; otherwise, accidents would occur. - Page 8 How to use [Starting up] Turn power switch to “I” marked position, then press on-off key on the control panel to start up the machine. After starting up, the machine runs on the mode of last power off. “+”key “-”key On-off key Timing key Mode key...
- Page 9 [Light screen off function] When the machine is on the working state, the screen automatically lights off and operating mode icon retains up if without operation within 1 minute. Press at the same time the key and “-” key for 2 seconds to close the light screen off function.
-
Page 10: Troubleshooting
MAIN TECHNOLOGY SPECIFICATIONS Power supply: AC 220-240V ~ 50Hz POWER REGULATION RANGE (W) MODEL HIGH STRONG MTFH-16401 1200 2050 2200 Troubleshooting If the product does not operate or does not operate properly, first check according to the following list. If the reason the product does not operate or does not operate properly is not included in the following list, the product may have a problem. - Page 11 Information requirements for electric local space heaters MTFH-16401 Model identifier(s): Symbol Value Unit Item Unit Heat output Type of heat input, for electric storage local space heaters only (select one) manual heat charge control, with Nominal heat output Pnom integrated thermostat...
-
Page 12: Notice About Recycling
CE Marking: 93 / 68 / EEC RoHS Directive: 11 / 65 / EU & 15 / 863 / EU The detailed declaration of conformity can be found at www.morris.gr Exclusive importer in Greece: Kalliopi Karyda & Co LP. 87A, 17is Noemvriou str, P.C. 55535 Thessaloniki –...
Need help?
Do you have a question about the MTFH-16401 and is the answer not in the manual?
Questions and answers