Troubleshooting - Breville Smooth Wave BMO840 Instruction Book

Troubleshooting

PROBLEM
Microwave oven
interfering with radio, TV
or similar equipment.
Dim microwave oven light
Stream accumulating
on door and hot air
coming from vents
POSSIBLE PROBLEM POSSIBLE REASON
Microwave oven
will not start
Microwave oven
does not heat
Glass turntable makes
noise during operation.
LCD time digit shows
EA1A then V1:00 or
similar information then
goes to default mode.
LCD time digit shows
00 for a short period
of time then shows 1 or
0 and stays at 1 or 0.
BMO840_ANZ_IB_C20.indd 31
EASY SOLUTION
•
Clean door and sealing surface of the oven
•
Reorient the receiving antenna of radio or television.
•
Relocate the microwave oven with respect to the receiver.
•
Move the microwave oven away from the receiver.
•
Plug the microwave oven into a different outlet so that microwave oven and
receiver are on different branch circuits.
•
When operating on low power levels, the microwave oven light may
be dimmer.
•
During operation, steam may be produced. Most will exit through the
vents; however, some may accumulate around the oven door.
•
Power cord not plugged in
properly or switched on.
•
Fuse blown or circuit
breaker problem.
•
Trouble with outlet
•
Door not closed properly
•
Turntable roller not
assembled properly or
needs to be cleaned.
•
Both 'STOP/Clear' and 'A
BIT MORE' buttons are
pressed at the same time
under the default mode.
•
Both 'STOP/Clear' and 'A
BIT MORE' buttons are
pressed at the same time
under the default mode.
EASY SOLUTION
•
Unplug, put the plug in again
and switch on.
•
Replace the fuse or reset circuit breaker.
•
Have a professional check that the outlet
is not faulty
•
Ensure door is shut properly
•
Reset and clean if necessary.
•
No action required. This is normal and
LCD just shows the model type and
software version.
•
If the LCD time digit stays at 0, send the
unit back to repair.
•
0 indicates Sensor IQ transducer
is not OK.
•
If LCD time digit stays at 1, Press STOP/
Clear to set the unit back to default mode.
•
1 indicates Sensor IQ transducer is OK
31
23/4/20 11:43 am