Xerox DC220/230ST Quick Install

Before Installation:
Record the following information for use during
setup at the DC220/230:
AppleTalk Printer Name:
______________________________________
Note: The DC220/230 will attach itself to the
default zone of the local segment where it is
connected.
1.
Connect the DC220/230 to your network
outlet or cable.
2.
Enter System Administrator Setups:
a)
Press the [Access] button on the
Control Panel.
b)
Enter the System Administrator
#22222
password by typing
(# key and 22222) on the keypad and
pressing [Enter] on the screen.
Note: #22222 is the factory default
password and may be changed by
your Xerox service representative to
suit your needs.
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797 Canada: 1-800-939-3769
The Document Company
XEROX
DC220/230ST AppleTalk
3.
Access the AppleTalk Setup screens:
a)
On the screen display, press [Print
Setups].
b)
Press [Network Setups].
c)
Press [AppleTalk].
4.
Enable AppleTalk:
a)
Press [Enablement].
b)
Press [Enabled].
c)
Press [Printer Name], then press
[Edit] and use the keyboard displayed
on the screen to enter the Printer
Name for your network (31 characters,
or less).
5.
Press [Save].
6.
Press [Save].
7.
Press [Exit]. The DC220/230 will reboot
and print a configuration sheet in approxi-
mately 3 minutes.
8.
Check the settings on the configuration
sheet against those that were entered.
® Quick Install
9.
To install the DC220/230 Macintosh
PPD:
a)
b)
c)
Additional information on the AppleTalk
installation can be found in the DC220/230
System Administration Guide.
Copy the DC220/230 Macintosh PPD
®
from the CentreWare CD to the
System Folder/Extensions/Printer
Descriptions folder.
Set up and configure the Print Driver
via the Chooser.
®
Refer to the CentreWare manual,
Getting Started with Print and Fax
Services for additional information.
©1998 Xerox Corporation
701P97986 Version 1.1, 5-98
®