Zigbee Network Communication Test; Unicast Test; Unicast Between End-Device And Coordinator In The Form Of Short Address - Ebyte E180-ZG120A User Manual

Zigbee

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

configuration also needs to be clicked. Write the parameters after modifying the network parameters, and finally restart to

join the new ZigBee network

7.3 ZigBee Network communication test

Enter the configuration mode, configure the target network address, and modify the target network address of the coordinator to

the local short address (0xFCFA) of the end-device. The destination network address of the end-device is 0 by default. 0 is the

coordinator's network short address (the coordinator's network short address is always 0). It does not need to be modified at this time.

If the end-device communicates with the non-coordinator node, it needs to be modified (modified to the destination node's network

local short address).

（2）After the target address between nodes is configured, click "enter transmission mode", and the message box will prompt

"enter transmission mode successfully". Before communication, confirm whether the module is in transmission mode, and only in the

transmission mode can the communication be realized. Input the data to be sent in the sending area, click send, and the received data

can be seen in the end-device node message box.

E180-ZG120A User Manual

Table of Contents