Network Operation Instruction Set; Hex Parameter Description; System Transmitting Mode; Receiving Data Output Mode - Ebyte E180-ZG120A User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

6.5.4 Network operation instruction set

Open network
Leave Network
Create network
Start Touchlink

6.6 HEX Parameter description

System transmitting mode

6.6.1
mode：
address in configuration mode);
address in configuration mode);
short address of the target device network);
number);

6.6.2 Receiving data output mode

mode：
0x00 transparent transmission（default）；
0x01 data+short address；
0x02 data+long address；
0x03 data+RSSI;
0x04 data+short address+RSSI；
0x05 data+long address+RSSI；
Note: the maximum package length is 72

6.6.3 Network node type

dev_type：
0x01 Coordinator
0x02 Router
0x03 End-device (default)
Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co.,Ltd.
Send：F5 01 40 01 FF
Return：FC 40 00
Send：F5 01 40 02 FF
Return：FC 40 00
Send：F5 01 40 03 FF
Return：FC 40 00
Send：F5 01 40 04 FF
Return：FC 40 00
0x00 Broadcast（default）；
0x01 (need to configure the target group number in configuration mode first);
0x02 Transparent transmission on demand + short address (need to configure the target short
0x03 transparent transmission on demand + long address (need to configure the target long
0x04 protocol on demand + short address (the first two bytes in the transmission mode are the
0x05 protocol multicast (the first byte in the transmission mode is the target network group
E180-ZG120A User Manual
Return：FA 38
Send：F5 01 40 01 FF
Return：FC 40 00
Send：F5 01 40 02 FF
Return：FC 40 00
Send：F5 01 40 03 FF
Return：FC 40 00
Send：F5 01 40 04 FF
Return：FC 40 00
1