Ebyte E180-ZG120A User Manual page 16

Chengdu Ebyte Electronic Technology Co.,Ltd.
Target network
Read/write
address
Local MAC
address
MAC
Target
Read/Write
address
Device type
Read/Write
Channel
Read/Write
Transmit mode Read/Write
Output mode Read/Write
Transmitting
Read/Write
power
Remote
configuration
Read/Write
ID
Local network
Read/Write
group number
Target network
Read/Write
group number
Wake-up period
Read/Write
(sleep time)
Network
Read/Write
opening time
Lost parent node
reconnection Read/Write
period
Maximum
number of
Read/Write
reconnections
IO state Read/Write
Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co.,Ltd.
The current device communication destination (short address) can
0x0000～
be switched at any time through configuration commands;
0xFFFF
Module factory MAC address, user can not be changed
Read 64bitMAC
In fixed-point mode, use long address to send;
64bitMAC
They are: coordinator, router, end-device and sleep end-device;
C、R、E、S
The physical channel through which ZIGBEE works;
CH11～26
0、1、2、3、 The transmission modes of the configuration module are: broadcast mode,
4、5 multicast mode, short address on demand mode, long address on demand
mode, protocol on demand, and protocol multicast. For details, please see
the corresponding mode function introduction;
The data output mode is:
Transparent transmission;
Data + short address;
0、1、2、3、
Data + long address;
4、5
Data + RSSI;
Data + short address + RSSI;
Data + long address + RSSI;
Module output power: 0 to 20dbm; high power consumption
requirements, where the distance is not required, the transmission
0～20dbm
power can be reduced to save average power consumption;
It is used to determine whether the data received by the air in the
air is a remote configuration command. The customer can change
2 byte
the unlimited configuration ID according to the requirements. The
default is A8 8A;
Used to configure the device number of the device in network;
0～255
Group number corresponding to the target when configuring device
0～255
multicast;
It is used to configure the wake-up cycle of the end-device sleep device.
0～2010s The larger the cycle is, the lower the overall power consumption is, but
the greater the delay of receiving data is;
It is used to configure the opening and closing of network security.
10～2540s During the opening period, the device can join the network, and during
the closing period, the device cannot join;
1～255 When the parent node is lost (the coordinator is powered down), the end-
minutes
device reconnects the previous network at regular intervals;
After the parent node is lost, the maximum number of
1 to 255 reconnections, if it has not been reconnected successfully, clears
times the previous network information, rescans the new network, and
the scanning period is equal to the reconnection period;
Access/control module level status of the GPIO channel;
High/Low
E180-ZG120A User Manual
1