Tpa 300 Standalone Mode; Check Tpms Sensors - Bosch TPA 300 User Manual

TPA 300 Standalone Mode

TPA 300 Standalone Mode is used to read, program and copy TPMS sensors, test
remote keyless entry (RKE), save and read recorded jobs, and setup the tool. To
register the TPMS sensor ID's into the vehicle ECU, use the TPA 300 Connect to
scan tool mode. See this user manual dedicated section to learn how to operate
this mode.
Select Standalone Mode
1

Check TPMS Sensors

This mode is to trigger all the TPMS sensors on the vehicle.
IMPORTANT: For best sensor triggering, hold the tool
against the tire sidewall right above the sensor.
1.1 Select Vehicle Manufacturer
© Bosch Automotive Service Solutions Inc.
IMPORTANT:
TPA 300 | User Guide | 11 | en-US
Continue
Continue
Previous
1699502721 | REV. A | MAY 2020