Related Manuals for Ingersoll-Rand 728 Series
Summary of Contents for Ingersoll-Rand 728 Series
- Page 1 16606022 Edition 3 May 2014 Air Drill 728 Series Maintenance Information Save These Instructions...
- Page 2 Product Safety Information WARNING Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious • injury. Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories •...
- Page 3 Assembly of the Gearing Needle Bearing inserting Tool 1. Press a Front Spindle Bearing (28) onto the threaded shaft of the Spindle Assembly (21) until it stops against the large face of the Spindle. 2. If the Spindle Bearing Retainer (32) was removed, use snap ring pliers to install it in the groove in the Motor Clamp Nut Assembly (31).
- Page 4 Troubleshooting Guide Trouble Probable Cause Solution Check air supply. For top performance, the air pressure must be 90 psig (6.2 bar/620 Low air pressure kPa) at the inlet. Plugged Air Strainer Screen or Inlet Clean the Air Strainer or Screen in a clean, suitable cleaning solution. If the Screen Screen cannot be cleaned, replace it.
- Page 5 Notes:...
- Page 6 Notes:...
- Page 7 Notes:...
- Page 8 ingersollrandproducts.com © 2014 Ingersoll Rand...
Need help?
Do you have a question about the 728 Series and is the answer not in the manual?
Questions and answers