Preparation Before Operation - Daikin FTKM25PVM Operation Manual

Preparation before Operation

To set the batteries
1. Slide the front cover to take it off.
2. Set two dry batteries AAA.
3. Set the front cover as before.
To fix the remote controller
holder on the wall
1. Choose a place from where the signals
reach the unit.
2. Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3. Place the remote controller in the remote
controller holder.
ATTENTION
About batteries
• When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
• When the system is not used for a long time, take the batteries out.
• Batteries will last for approximately 1 year. If the remote controller display begins to
fade and the degradation of reception performance occurs within a year, however, replace
both batteries with new size AAA alkaline batteries.
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
About remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such
as inverter-type lamps) is in the room . Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance
to somewhere else, or consult the shop.
2
Position
–
correctly!
3
1
Remote controller
Screws
Remote
controller holder
+
and
9