Download Print this page

Ashford WARPING FRAME - Large Instructions

Download this manual

Maximum Warp Length:

Assembly Instructions

Apply a little glue to each hole and push the pegs in (hammer if necessary). Fix the frame together at the

four corners, using a bolt, washer and nut. Hammer bolts into place if necessary.

Attach the rubber feet with small screws into the pilot holes in the back of the rails.

Parts List

Rails with 5 holes

Rail with 4 holes

Rubber feet

Small panhead screws

Ashford Handicrafts Limited

Factory and Showroom: 415 West Street

PO Box 474, Ashburton 7700 New Zealand

Telephone 64 3 308 9087 Facsimile 64 3 308 8664

Email: sales@ashford.co.nz Internet: www.ashford.co.nz

INSTRUCTIONS

WARPING FRAME - Large

Approx 11 metres / 37 feet

Bolts with nuts and washers

Bottle of glue

Pegs

Ashford Guarantee

Thank you for purchasing this Ashford product. In the unlikely event there is

any fault in manufacture we will replace the item. To validate our guarantee

please visit our website or write to us.

WF120318V5

Page 1 Ashford Guarantee Factory and Showroom: 415 West Street Thank you for purchasing this Ashford product. In the unlikely event there is PO Box 474, Ashburton 7700 New Zealand any fault in manufacture we will replace the item. To validate our guarantee Telephone 64 3 308 9087 Facsimile 64 3 308 8664 please visit our website or write to us.
Page 2 For more information, helpful hints and inspiration we recommend the Learn to Weave on the Table Loom booklet, The Ashford Book of Weaving for the Four Shaft Loom by Anne Field and The Ashford Book of Projects for the Eight Shaft Loom by Elsa Krogh.