Setting Up; Unpack The Carton; Install The Batteries - Bose Wave Radio Owner's Manual

Unpack the carton

Carefully unpack the carton. Do not attempt to use the Wave
aged. Instead, repack the carton and notify Bose
®
Place the Wave radio on a table or other flat surface. Locate the FM and AM antennas, the
power cord, and the AA batteries.
Wave
®
radio
Power cord
FM antenna

Install the batteries

®
The Wave radio's three AA batteries maintain its memory and backup alarm system for up to
a week during a power failure, or while the radio is unplugged. The batteries will not power the
radio or light the display. Operating without batteries leaves the memory unprotected, but will
not harm the radio. Use only 1.5V AA alkaline batteries (IEC-R6 in Europe), available at many
retail stores.
1. Carefully turn your Wave
upside down (avoid scratching
its top).
2. Locate the battery compart-
ment on the bottom (see
Figure 2).
3. Press the arrow on the cover to
slide the compartment open.
4. Place the batteries inside,
matching the + and – symbols
with the symbols inside the
compartment.
5. Slide the cover back into place
and turn the radio right side up.
AM149204_02_V.pdf
(see Figure 1)
®
or your authorized Bose dealer immediately.
Lithium
battery
Peel-and-
stick tape
AM antenna clip
® radio
172087
50W 50-60HZ
120V~AC
January 7, 2002
®
radio if any part appears dam-
AA batteries
Remote control
AM loop antenna
+ – +
OUT VARIABLE
IN AUX
L R

Setting Up

Figure 1
®
What comes with your Wave radio.
®
• One (1) Wave radio
• One (1) power cord
• Three (3) AA batteries
• One (1) FM antenna
• One (1) AM antenna
• One (1) AM antenna clip
• One (1) peel-and-stick tape
• One (1) remote control
• One (1) lithium battery
Figure 2
Match the + and – symbols on the
batteries to the marks inside the
compartment.
5