Remote Control; Air Filter - Tectro TP 2020 Operating Manual

C B E
B D
A
D
4
56
When the unit is switched off the most recent setting will be stored in
memory.
The timer function allows you to switch the unit on or off at a certain time.
1. Press TIMER button to set the operating hours you desired and the buttons p
3 and q 4 (1 to 24 hours, the timer indicator will light on). When the set
time has been reached, the machine will turn off automatically. The display
window will show the hour(s) you set as you press TIMER button. If the timer
button is not pressed, the unit will work continuously.
2. By pressing the timer but without turning on the other functions, you can
PRE-SET the time for the machine to work. For example, if you press the timer
to '2', the unit will work automatically after 2 hours.
G
NOTE!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner. The cooling will switch off
when the room temperature is lower than the set temperature. Air
circulation will however continue to work on the set level. When the
room temperature rises above the set temperature, the cooling will
work again.

REMOTE CONTROL

a. Power on/off button
b. Temperature +/- buttons
c. Fan Speed button
d. Timer button
e. Function button
The remote control works in combination with the control panel. Aim the front
end of the remote control at the control panel. The maximum operating distance
from the air conditioner is approximately 5 metres. Place 2 pieces of 2xAAA type
1,5 V batteries before use.

AIR FILTER

The air conditioner is equipped with a screen filter to remove the bigger dust
particles.
The screen filter has to be cleaned 2x a week. Clean the air filter with a neutral
detergent in lukewarm water (40ºC) and allow to dry slowly.
To take out and place back the screen filter, see pictures at the side.
G
NOTE!
• Never use the air conditioner without the air filter.