Table of Contents
Advertisement
Necessary functions before using
Necessary functions before using
Trial Operation
The trial operation is to check the installation status of the product.
The temperature will not be controlled during trial operation.
Instead the product will operate in several modes such as cooling, strong wind, comp-on Auto Swing.
PQRCFCS0
Defrost
Preheat
FAN
SPEED
* This function might not be available for Multi Product like Multi V system.
12 Junction Simple Wired Remote controller
Out door
Room Temp
Total on
Central Run
1
If you want to set the trial operation mode, press the
Fan Speed button and None button same time for 10
seconds.
2
Then the product will begin the trial operation and the
display will be like as shown on left side picture.
3
If you want to cancel the trial operation mode, just
press the On/Off button.
4
The trail operation will be shut down automatically
after 18 minutes and system will go to the standby
mode.
Advertisement
Table of Contents
