Table of Contents
Advertisement
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
•
Do not use a product with defective safety devices.
•
Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
Fuel safety
WARNING: Read the warning instructions
that follow before you use the product.
•
Fuel is flammable and the fumes are explosive. Be
careful with fuel to prevent injury, fire and explosion.
•
Do not breathe in the fuel fumes. The fuel fumes are
poisonous and can cause injury. Make sure that the
airflow is sufficient.
•
Do not remove the fuel tank cap or fill the fuel tank
when the engine is on.
•
Let the engine become cool before you refuel.
•
Do not fill fuel in an indoor area. Not sufficient airflow
can cause injury or death because of asphyxiation or
carbon monoxide.
•
Do not smoke near the fuel or the engine.
•
Do not put hot objects near the fuel or the engine.
•
Do not fill fuel near sparks or flames.
•
Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
•
Fuel on your skin can cause injury. If you get fuel on
your skin, use soap and water to remove the fuel.
•
If you spill fuel on your clothing, change clothing
immediately.
•
Do not fill the fuel tank fully. Heat causes the fuel to
expand. Keep a space at the top of the fuel tank.
•
Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
•
Before you start the product, move the product to a
minimum of 3 m/10 ft from where you refueled.
•
Do not start the product if there is fuel or engine oil
on the product. Remove the unwanted fuel and
engine oil and let the product dry before you start the
engine.
•
Examine the engine for leaks regularly. If there are
leaks in the fuel system, do not start the engine until
the leaks are repaired.
•
Do not use your fingers to examine the engine for
leaks.
•
Keep fuel in approved containers only.
•
When the product and fuel is in storage, make sure
that fuel and fuel fumes cannot cause damage.
•
Drain the fuel in an approved container outdoors and
away from sparks and flames.
1299 - 001 - 14.04.2020
Electrical safety
WARNING: Read the warning instructions
that follow before you use the product.
•
The power plug must agree with the power outlet. Do
not do modifications to the plug. Do not use adapter
plugs with grounded products. Power plugs without
modifications, and correct power outlets decrease
the risk of electrical shock.
•
Do not pull the power cord to move the product.
•
Pull the power plug to disconnect the power cord. Do
not pull the power cord.
•
Make sure that the power cord does not catch in
doors, fences or equivalent obstacles that can cause
damage to the power cord.
•
Do a check that the power cord and the power plug
are in good condition and not damaged.
•
Do not connect a damaged power cord to the
product.
•
Do not touch the power cord if it becomes damaged
during operation of the product. Disconnect the
power cord from the power outlet.
•
Keep the power cord away from water, oil, sharp
edges and moving parts.
•
Keep the product away from rain and wet conditions.
The risk of electrical shock increases if water goes
into the product.
•
Use a power supply with RCD (residual-current
device) protection if you operate the product in a
moist environment. An RCD decreases the risk of
electrical shock.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product.
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
•
Stop the engine and make sure that all parts of the
product are cool before you do the maintenance.
•
Clean the product to remove dangerous material
before you do the maintenance.
•
Disconnect the spark plug cap before you do the
maintenance.
•
The exhaust fumes from the engine are hot and can
contain sparks. Do not operate the product in indoor
areas or near flammable material.
•
Do not change the product. Modifications that are
not approved by the manufacturer, can cause
serious injury or death.
7
Advertisement
Table of Contents
