Vertical Steam Ironing; Dry Ironing - TECHWOOD TFS-246 Instruction Manual

The iron in a vertical position, set the temperature control dial at the minimum/low
heat setting.
Insert the plug into the socket.
The blue light turns on, indicating that the power is on.
Turn the temperature selector to the "high temperature" mark. The red light will
come on, indicating that the iron is heating up.
Notes : When the red light turns off, the set temperature is reached and the iron is
ready for use.
During ironing, the iron light turns on and off automatically to indicate that
the thermostat is holding the sole, to the settled temperature
Steam is produced as soon as the iron is maintained horizontally.
Turn the steam control knob to the desired position.
Lift the steam iron from its base and start ironing.
Important note : The iron can be used +/- 45 seconds before to be rested on its
base to be recharged. It recharges in 4 seconds for a new use of 45 seconds.
Press the spray button to spray water on clothes, as often as required.
Notes : When using the water spray function, ensure that there is enough water in
the water tank.
You may have to pump the spray button serval times at first time you use
the iron in order to start the spraying function.
Press the express steam button to generate a powerful jet of steam that can
penetrate the tissues and smooth out the toughest and most stubborn wrinkles.
Notes : In case of rebel creases, spray a little water before using the express
steam button.
By pressing the steam button at regular intervals it is possible to use it
vertically for curtains, hanging clothes, etc.)
The steam function can only be used at high temperatures.
Stop express steam emission when the indicator light comes on, and start
again as soon as the indicator light goes out.
For ironing without steam, follow the instruction in section "steam ironing",
however, the steam control turning knob should remain in position "O" (no steam).
STEAM IRONING
SPRAYING

VERTICAL STEAM IRONING

DRY IRONING

8