Quick Setup - Kidde KN-COB-DP-H Manual

Quick Set Up D i a g r a m
We urge you to read this entire manual
TEST/RESET
BUTTON
in the sequence it is presented.
Listed below are five easy steps for setting up your Kidde CO
alarm for operation. Please read the entire guide for complete
information.
Step 1
Determine the best location for your CO alarm(s). Usually this is GREEN OPERATE
LED
in or near bedrooms. Refer to Recommended Locations for
complete information.
RED ALARM LED
SOUNDER ALARM
Step 2
For model KN-COB-LCB-A remove the yellow pull-tab or install
the battery shipped with your unit. Plug the CO alarm into a
standard, unswitched 120 volt AC electric outlet.
M O D E L
Step 3
K N - C O B - D P - H
The green operate light will come on and stay on, showing the
CO alarm is receiving power.
Step 4
Next, test the alarm's operation by pressing and releasing the
POWER-DISCONNECTION ALERT POWER-DISCONNECTON ALERT
Test/Reset button. The unit will beep quickly 4 times – followed
SWITCH PEG
by 5 seconds of silence – followed by 4 quick beeps. This is
also the alarm cycle in the event of a CO problem. Familiarize
yourself and other residents in the home with this alarm pattern.
The red alarm light will come on when the alarm sounds.
M O D E L
K N - C O B - L C B - A
Step 5
While testing the CO alarm, have someone else check that the
alarm can be heard easily from the sleeping areas. The CO
alarm should be located where it can wake you if it alarms at
BATTERY DOOR
night. Your Kidde CO alarm is now monitoring for the presence
of carbon monoxide.
SCREW
3 4