Installation and Configuration
RS-232 Connection
RS-232 Connection
26
WARNING
Do not operate the power supply and the computer at significantly different frame
potentials. The interface connection system may not be capable of handling the
resulting excessive ground currents.
Use an approved RS-232 connector and cable when connecting the RS-232
Interface to your computer. The RS-232 connector uses the 9 pin mating connector
J4 on the rear panel. Figure 2.4 shows the connector pinouts for the RS-232
connector. Refer to Figure 2.2, on page 17 for the position of the RS-232 connector
on the rear panel subplate.
Figure 2.4 RS-232 Connector (J4) Pinouts (default configuration)
Operating Manual for RS-232 for XPD Series Power Supply