Beef Eater Discovery 1100 Series Assembly page 2

Content:
Bolt Pack Content
Mrk Qty
B 2
D 6
E 2
K 2
1
For Basic configuration installation, full Bolt Pack can be found inside the Base Shelf carton.
2
To be used in ALL installations.
3
To be only used for additional cabinet installations.
Instructions
Note: the full assembly instructions can be found in the Base Shelf Carton. These
instructions only refer to additional modules!
Position each cabinet to be added in its correct position, level it with the Outdoor Kitchen, and then
fasten to the near cabinet with the 4 screws included in this pack as follows:
1
In position (see below), 2 x screws 'B', washers and nuts.
2
In position (see below), 2 x special screw 'K' – thread through both cabinets and tighten.
• Holes on the very end panels can be hidden using plugs 'G', 'H' and 'I' supplied in main
Bolt pack.
• Each cabinet is fitted with 4 adjustable feet. The Outdoor Kitchen can be leveled by
adjusting these feet up or down, turning with the Allen key (supplied in main Bolt pack)
from inside the cabinet, through the holes in the corners.
1100_ODK_Ext_Inst_AU_V0
1
description
2
M6 x 12 screw
2
Fiber washer
2
M6 Nut
3
M6 Special screw
Images in this manual are for illustrative purposes only.
Due to constant improvement, BeefEater advises that changes to
the design, material, specifications and product configuration may
occur at any time without notice.
2