Dirna Minicool Compact Mounting Instructions page 24

EN
Place the evaporator front on previous studs
10
with (1) M6 wide ring washer and (1) M6
nut on each stud. Tighten nuts until air ducts
systems touch upper foam gasket (see diagram
bellow). Important: Air ducts must touch
foam gasket to avoid air leaks.
10
EPDM
Gasket
Cabin roof
Upholstey
Tighten nut mentioned under point 9a until it
11
touches upper surface of front.
11
EPDM
Gasket
Cabin roof
Upholstey
Place console and centre equipment in the most
12
convenient place of cabin roof. Once centred,
remove console for later installation.
Unit base
Nut M6
Stud M6
Unit base
Nut M6 (9a)
Nut M6
Stud M6
Air ducts
Air ducts
24
dirna
, s.a.
Foam Gasket
front with louvers
Foam Gasket
front with louvers