Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Whirlpool UT750/IX
Summary of Contents for Whirlpool UT750/IX
- Page 1 Model UT750/IX ：...
-
Page 2: Table Of Contents
ontents Important safety instructions Before using the hood Installation Mounting method Hood operation Maintenance & Cleaning Speci cations Hood measurement Replacing lamps Wiring diagram... -
Page 3: Important Safety Instructions
These instructions shall also be available on website: www.whirlpool.com.hk KEEP THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE. YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. - Page 4 mportant afety nstructions follow Gas appliances must be used under the extractor hood. When using more than three gas burners, the hood should be operating at power level 2 or greater. This will eliminate heat congestion in the appliance. Before t Do not use or leave the hood without its lamps correctly installed-risk of electric shock.
-
Page 5: Before Using The Hood
After unpacking the appliance, check for any transport damage. Do not install the appliance if it has been damaged. In the event of problems, contact Whirlpool Customer Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. -
Page 6: Mounting Method
ounting ethod this appliance must be earthed. Supply cord must be disconnected from power source before connection (to the appliance). 1. Cut out an opening in the bottom of the cabinet by following the 690mm dimensions in FIG 1 . 3. -
Page 7: Hood Operation
peration Power • Button to • This hood has memory function. Hood will start with power and light setting according to the fan at Press button again and the hood will turn back on at speed 3 and high lights.) •... -
Page 8: Maintenance & Cleaning
& C aintenance leaning Always disconnect from power supply before cleaning. A. Hood Surface Maintenance 1. Please clean the hood surface regularly with mild detergent and wipe with a cotton cloth to prevent grease from accumulating. 2. Please do not use abrasive nor corrosive cleaning agent to clean the surface because this will damage the surface. -
Page 9: Speci Cations
Model UT750/IX Net Weights 11.1 Kg Gross Weights 14.1 Kg Hood Size W x D x H 748 x 320x 382 mm Packing Size W x D x H 890 x 420 x 375 mm Voltage 220V , 50Hz... -
Page 10: Replacing Lamps
• Always disconnect the appliances from power supply before replacing lamps. • Use protective gloves. Never dismantle, repair or modify the appliance by yourself. for anyone other than the above mentioned people to perform repair service. Please contact Whirlpool Customer Service to purchase new LED light strip for replacement. clip... -
Page 11: Wiring Diagram
iring agram... - Page 12 (除本手冊有提供指引外，請勿擅自對抽油煙機進 行修理或拆卸任何機器內的部件。) 別說 10 . 。...
- Page 13 ，因可能會有 觸電 的危 險。 不 應室外使用此電器或用作商業用途 。...
- Page 14 （ ） b.塑膠風管圈 1個 安裝配件1包 (#6 x 1" 木螺絲 x 4 支 、 M4 x 8 螺絲 x 2 支 、 3/16 x 5/8 華司頭螺絲 x 2 支 、華司 x 2 片 + 固定片 x 1 個) 安裝指引 建議油煙上升至250毫米以上，抽油煙機始能充分 發揮抽油煙效果。 ‧...
- Page 15 安裝 方法 毫米 1.根據圖一所顯示的尺寸在廚櫃底部開孔。 2.將油煙機的濾網拆下。 3.使用(2)M4 x 8螺絲將塑膠風管圈安裝至機器上方。 櫥櫃底部開孔尺寸 4.將機器放至廚櫃並確認固定彈片確實固定在正確 (圖一) 位置。 (固定彈片位置在機器左側，如圖二。) 正視圖 5.將(2)#6 x 1"木螺絲鎖在機器兩側。 塑膠風管圈 注意:依實際安裝需求是否需要增加木塊加強廚櫃 木頭 底部。(圖二) 6.將面板與機器對齊並使用(2)3/16 x 5/8華司 固定彈片 開關 頭螺絲及(2)華司，將固定片固定到機器前方。(圖三) (圖二) 7.安裝電源線和排風管，使用膠帶密封排風管 (選配)。 正視圖 塑膠風管圈 8.開啟油煙機，並檢查風管連接處有否排風外洩。 9.在馬達外殼中心安裝油杯。 10.使用油煙機前請撕除保護膜。 (圖三) 11.裝回濾網。...
- Page 16 ‧ ‧ 煙機會在高速和照明全亮的狀態下再啟動。) ‧ ‧ ‧ -> -> ‧ ‧ ‧ ‧ ‧ ‧...
- Page 17 ， ） 將把網扣微拉出取出濾網。(圖4) FIG. 4...
- Page 18 UT750/IX 11. 1 公斤 14. 1 公斤 748 x320x382 毫米 890x420x375 毫米 220V,50Hz LED 9W 毫米...
- Page 19 更換照明燈 ： • L E D ， 。 移除 濾網， 拆除內 部條燈連 接電線。 將兩 邊彈片 同時壓 後，即可 移除燈條。 (如 下 圖) 彈片...