Front Panel Functions - Marshall Amplification CODE50 Owner's Manual

FRONT PANEL FUNCTIONS

2 15 16
1 3 4
Connect via USB to use CODE as a DAW interface, to play tracks from your music library 1. USB
and to get irmware updates.
To record with CODE using your DAW:
• Connect to your computer via USB.
• Select your CODE ampliier as the input
source on your computer and within
your DAW.
To stream audio from your computer
through CODE:
• Connect to your computer via USB.
• Select your CODE ampliier as your
computer's output source.
• Use the MASTER control to adjust the
volume level (#9 in this manual).
ENGLISH
17 18 19 20 21
5 6 7
To get CODE irmware updates:
http://my.marshall.com/Downloads
Follow this link to quickly and easily keep
your CODE ampliier's irmware up to date.
MIDI data:
• Your CODE ampliier can also send and
receive MIDI data related to the front
panel controls via the USB.
22 23
8
Use this jack socket to connect your 2. INPUT
guitar to the ampliier. Use a good quality
screened/shielded guitar cable to help
prevent noise interference.
Controls the amount of Gain introduced to 3. GAIN
a Preset. The higher the Gain, the harder
the preamp is driven.
4. BASS
Turning the BASS control will adjust the
warmth and low-end depth of your sound.
Adjusting the MIDDLE control will vary the 5. MIDDLE
amount of body in your sound by boosting
or cutting midrange frequencies.
6. TREBLE
Increasing the TREBLE will make your
sound brighter and more cutting. Turning
the TREBLE down will decrease tonal edge
and make the sound softer.
9 11
10 12 13 14
Controls the volume level within a selected 7. VOLUME
Preset (#8 in this manual).
Because GAIN, BASS, MIDDLE, TREBLE
!
& VOLUME are stored as part of a Preset,
these panel tone controls only become active
when they are used. This means that until
they are turned their position is not related to
their setting within a Preset. When you turn
a tone control it becomes active. The display
screen will show its current setting and the
stored setting.
When a GAIN, BASS, MIDDLE, TREBLE
!
EXIT/STORE LED will lash red to show that or VOLUME control is activated the
the Preset's stored settings have changed.
ENGLISH