Bosch Professional GLL 2 Original Instructions Manual page 10

10 | English
Cross line laser
Dimensions (length × width × height)
A) The working range may be reduced by unfavourable environmental conditions
(e.g. direct sunlight).
B) Only non-conductive deposits occur, whereby occasional temporary conductivity
caused by condensation is expected.
The serial number (13) on the type plate is used to clearly identify your measuring tool.
Assembly
Inserting/Changing the batteries
It is recommended that you use alkaline manganese batteries to operate the
measuring tool.
To open the battery compartment cover (10), press the locking mechan-
ism (11) and lift open the battery compartment cover. Insert the batteries.
When inserting the batteries, ensure that the polarity is correct according to
the illustration on the inside of the battery compartment.
Always replace all the batteries at the same time. Only use batteries from the
same manufacturer and which have the same capacity.
Take the batteries out of the measuring tool when you are not using it
u
for a prolonged period of time. The batteries can corrode and self-dis-
charge during prolonged storage in the measuring tool.
Operation
Starting Operation
Protect the measuring tool from moisture and direct sunlight.
u
Do not expose the measuring tool to any extreme temperatures or
u
fluctuations in temperature. For example, do not leave it in a car for ex-
tended periods of time. If it has been subjected to significant fluctuations
in temperature, first allow the measuring tool to adjust to the ambient
temperature and then always carry out an accuracy check before continu-
ing work (see "Accuracy Check of the Measuring Tool", page 13).
The precision of the measuring tool may be compromised if exposed to
extreme temperatures or fluctuations in temperature.
1 609 92A 58R | (04.03.2020)
GLL 2
77 × 63 × 84 mm
Bosch Power Tools