Configuration Procedure - National Instruments VXIpc-486 500 Series Getting Started

Chapter 2

Configuration Procedure

Follow these steps to modify the factory configuration:
1. Ground yourself and the VXIpc-486. The VXIpc-486 can be damaged by static discharge.
You are less likely to damage the VXIpc-486 if you place it on a properly grounded
anti-static mat and use a wriststrap.
2. Remove the screws that secure the right side cover. Remove the cover to expose the circuit
board.
3. Alter the configuration as required, as described in the following section.
4. Replace the cover and the screws.
Art not available in PDF version of document.
Figure 2-1. VXIpc-486 Model 500 Series Parts Locator Diagram (Continued)
© National Instruments Corporation
VXIpc-486 Configuration and Installation
2-3 VXIpc-486 Model 500 Series