Nasco Healthcare LF01274 Light Instruction Manual page 8

Reassembling the Arm
A. Feed the inlet/outlet tube through the large channel and out the
hole in the upper arm. Replace the muscle pad over it.
B. Shake baby powder into the inside of the arm (see Figure 8). Pinch
the end of the arm skin closed and shake the arm to distribute the
powder inside the skin.
C. Position the skin shoulder opening below the fingers and
simultaneously pull and roll the skin up to bring the skin finger
section to the core fingers (see Figure 9). Caution - work the skin on
gently.
NOTE: Plastic wrap is occasionally used during the manufacturing
process to keep the veins in place. Plastic wrap can be used
prior to sliding the skin into place to assist in keeping the veins
in place during this process.
D. Guide the fingers and thumb carefully into the proper holes.
Mistakes can be corrected by sliding the skin back an inch or two
from the fingers and beginning again.
E. After the fingers are positioned in the hand, unroll and slide the
skin over the core to provide a snug fit. (See figure 10.)
8
Figure 8 Figure 9 Figure 10