Nasco Healthcare LF01274 Light Instruction Manual page 6

Figure 5
C. Refer to Figure 5 (Green). Plug one end of a uniform diameter tubing
piece into fitting #2. Press the tubing into the channel, around the
loop near the wrist, and back to the connector block at fitting #3,
trimming excess.
Figure 6
D. Refer to Figure 6 (Yellow). Using the shorter piece of multi-diameter
tubing, plug the long end of the tubing into fitting #7. Work it into
the channel down the forearm, around the palm side of the thumb,
and back toward the connector block in the same channel. Pass
the tubing over the first section of "green" tubing and under the
second section (refer to diagram above). The couplers should be
approximately in the positions shown in the diagram. Connect the
tubing to fitting #5, trimming excess.
6