Nasco Healthcare LF01274 Light Instruction Manual page 4

Removing the Arm Skin & Veins
A. To remove the skin from the arm core, bend the skin flap around
top of arm.
B. Remove the inlet and outlet tubes from the arm skin.
Note: If you are replacing the skin and the veins, simply cut the skin
free from the arm core using scissors and discard. If replacing only
the veins, pull the skin down only far enough to expose the veins
without removing the skin completely from the fingers. This will
make it easier to pull the skin back on when finished.
C. Remove the foam shoulder injection pad. (See figure 2.)
D. Remove the bicep muscle located over the manifold.
E. Remove the old "veins" from the grooves, unplug them from the
manifold, and discard them.
F. If needed, clean the arm core with soap and water.
4
Figure 2