Getting The Remote Ready To Use; To Install Batteries - Bose LIFESTYLE RC-18S Owner's Manual

Getting the remote ready to use

Figure 2
Polarity marked on
the batteries
Preparing the Remote
You can use your RC-18S remote control as soon as the
batteries are installed. It is pre-set at the factory for use
outside the main room where your LIFESTYLE
located, in an area where another Bose
speaker pair is set up.
Or, you can use it as a secondary remote in the same
room with the LIFESTYLE
to set switches inside the battery compartment for that
purpose, refer to "How to change the settings, as needed"
on page 15.

To install batteries

1. Slide the battery cover off the back of the remote.
Note: You may notice the small switches just above the
batteries inside the compartment. These are the house
code, stream selection, and room code switches,
explained on page 12.
2. As you install the four supplied batteries, match the
polarity markings (+ and –) on each one to markings
inside the battery compartment (Figure 2).
3. Slide the battery cover back into place until it snaps
closed.
Note: If you notice a decrease in the range or response of
the RC-18S remote control, the batteries may need to be
changed.
Preparing the Remote
®
system instead. To learn how
+
+
+
+
®
system is
® system or
7